TQ vs. CDU-bay

[NAX228]

Hi sirs
I have tried to find some pics showing how the TQ "hits" the CDU bay without any luck.
Does anyone of you have the right heights? And if you do, can you post a pic?

Awaiting some french aluminium this week

[jackpilot]

maybe....that's all I have

[sean nixon]

This is all I have...

[NAX228]

Thanx both. Now I know approx how high it should be.

[MLeavy737]

What Measurement do you need exactly? Ill take a pic and get the exact one from the airplane. Im flying again in a few days

Mike Leavy

[NAX228]

Hi
I'm thinking about the area where the TQ meet the CDU bay. A pic directly from the side would be much appreciated.
It looks like the edge of the TQ box is a little higher then the CDU bay.
I have already adjusted the MIP 26mm, just over 1", to add somewhat up to the CDU bay, and I suspect the CDU bay wont match up to the hight of the TQ.

Hope you get what I mean. It was'nt covered in the Markuspilot document.

[MLeavy737]

Yeah i see what your talking about. Ill get a pic in a few days. I think im in an 800 tomorrow. And i do think the CDU bay is slightly lower from what i remember.

Mike Leavy

[MLeavy737]

Got the picture your looking for. Have it on my iphone. Ill transfer to computer and upload it in a few days when i get back home. Its from a 73-900 but all the same. NG that is.

Mike Leavy

[JWS]

Mike,

if it's not too much trouble, could you please have a look at the panel underneath the MIP (where the light panels are situated). What hight & anle has it with respect to the CDU??

Much appreciated.

JWS

[sean nixon]

Is this any help?

http://www.airliners.net/photo/Continental-Airlines/Boeing-737-924/0190890/L/

[MLeavy737]

I took the pic you need. Ill upload it tonite when i get home.

Mike Leavy