Hello if anyone could help me with this. I am now trying to set my ailerons. ALL axis's are deleted in P3d. I have no problem calibrating the ailerons except on the same page when I move them, the Throttle axis moves!!! I allready have my Throttles 1 and 2 set and calibrated and working fine. So now When I start a flight my throttles go full when I move my yoke!. Any help would be great.
How are you getting data to FSUIPC, through a Leo Bodner card or equivalent.
I would suspect a bad analog input card. This assumes as you said all inputs in P3D are off, including turning off controls completely.
in the FSUIPC/Simflight-Forum you'll find report about problems with new P3D Version 4.2 . Unfortunately Pete D. is on vacation until Tuesday.......
Regards
Bernhard
I am using a Leo Bodner card. I am also running P3d v3. Its a brand new card that I got friday...
I have FSUIPC installed, but do not use it to interface my joystick axis'. Have you taken the time to read the documentation? It is found here:
\Lockheed Martin\Prepar3D v3\Modules\FSUIPC Documents\
Hello, no I have not read the documentation in P3d for this. I will when I get home. I will aslo check to see if controllers are disabled. I know for sure that all axis assignments are deleted...Thank you all for the input.
Just know that FlightSim has a nasty habit of putting them back when it senses a new controller added.
Delete your FSUIPC ini file and let it generate another one. I have had it in the past where
everything looks good but some data still remains. :2cw:
OK thanks guys for the responses. I'll report back. Thanks again.
Hello I disabled controllers and that did the trick. Thanks guys ;D