Cockpitbuilders.com
Project Magenta - Unofficial => Boeing Software - Discussion => Topic started by: GSalden on October 04, 2016, 04:04:58 AM
Recently I updated all PM modules.
I now have the issue that when turning on the yaw damper switch it immediately goes to off...
This is with the engines running.
All suggestions are welcome.
Thanks,
Gerard
I have this same issue. I just have not tackled it yet.
This can be an IRS issue.
The IRS posittion when I set the airport in the CDU is slightly different than what the IRS shows.
This can be seen on the same CDU page too.
I snet a tickt to PM 4 days ago, but no reply yet ( Last time I got an answer on a ticket after 5 months... )