Prosim lost my FDS Interface board....

[737man]

Hey Guys,

I updated the Prosim737 to 1.40 yesterday.  I then lost my FDS interface board on my prosim modules list. 

http://www.flightdecksolutions.com/components/interface-it/fds-sys4x-high-capacity-64in-128out-card/

It is connected and I hear a chime when connected.  How can I get it back on the list.  before I lost the module I had configured all the switches / led's etc???

I did have to reconfigure the TQ from revolution.  It seemed to have lost all those too.  The prosim did show the TQ in the modules though....

Any thoughts would be great.

[Sam Llorca]

Reset USB and/or restart the computer, it should show all the connected boards,
On the configuration  page, make sure the FDS box is checked.

Hope it helps.

[737man]

Where is the box located

[Aerosim Solutions]

Lots of builders are having this issue. I believe the FDS FMC software has to be deleted and as Sam says tick the FDS box, it's probably in the drivers tab. I haven't done it yet but will do so soon.

Cheers Gwyn

[jackpilot]

Subject widely debated on prosim Forum.
Prosim has now  FDS hardware "native" which means that you do not need Teckworks drivers and have to remove them.

http://prosim737.com/forum/viewtopic.php?f=60&t=7507

http://prosim737.com/forum/viewtopic.php?f=60&t=7514&sid=e5d79e2b89954d027c192679b6c58e18

[Sam Llorca]

Make sure you have deleted FDS Glare, CDU controller and Interface IT, like Jack said, ProSim737 now supports native FDS drivers, need to download and install FDS driver installer from ProSim.

Very stable without TEXWork.

Hope this helps