My 737

[Bob Reed]

I have been working on the sim for the last couple of weekends and I am getting ready for some pretty big upgrades. Starting to setup PMSystems and have the RCDU operational. More tweaking of buttons and getting the MIP ready. Now to figure out how I am going to move the MCP out about 12" from where it sits. It is pretty heavy!

[smg id=1187]

Playing with my radios to get them ready.

[727737Nut]

Looking great Bob! 

[Bob Reed]

Well that center council that I have had for years is about to go away as well. Big changes coming to the old 73...

[RayS]

There ARE big changes coming!

I will get to the post office this weekend and get the CDU bay shipped. 

[jr2mey]

Bob, looking good sir!!!! how goes the adjustments to the MIP?

Did you ever get the Pot changed out in your Throttles?

I'm not working on my sim this weekend as I'm spending time with family however next weekend will be sim fest time!

[Bob Reed]

Bob, looking good sir!!!! how goes the adjustments to the MIP?

Did you ever get the Pot changed out in your Throttles?

I'm not working on my sim this weekend as I'm spending time with family however next weekend will be sim fest time!

Well Adjustments to the MIP can not start until I get the PFC yoke repotted so I can remove the yoke that is fastened to the MIP stand. Does someone have a link to hall effect sensors? Then I need to figure out how to move the MCP out from where it is located about 12". That thing is heavy. Then I can see about dragging the MIP out. I think I have the 19" wide screen LED monitors I need. lol I think you get the picture. TQ still needs pot work.. Hmmmm maybe more hall effects? Never ends, does it?

[iwik]

Bob,
See this for Hall Effect sensors, both 90 and 180 degrees available.

http://eu.mouser.com/ProductDetail/Honeywell/HRS100SSAB180/?qs=4VIqrSC5RMjdXmeUaOxqBg%3d%3d

les

[Bob Reed]

Thanks Les!