Switch Wiring

[props]

Hello fellow simmers, I working with the Leobodnar Buo836x card and I wondering would it be possible to wire a spst switch that illuminates to the card.
See that a spst common switch works,just wondering how?
                                                                                               Thanxs again

[iwik]

Hi,
If you mean you want to light a led when switch is closed. Then connect
a 470 ohm resistor in series with a led  from 5v to Buo386x input. Anode
to 5v.
Les

[props]

Hey Les thanks for the respond, a three prong switch one to power, one to ground and one with the resister to the card ??
this is my first time
                                                                                                Props

[iwik]

No,
Centre of your switch to gnd. Either end to input of card. Cathode of Led
to input in series with resistor to 5v. Switch closes signal sent via card
to FS and led turns on.
See here   

http://www.leobodnar.com/files/basicLEDswitch.pdf
les

[props]

Hey that works pretty good thank you, iwik
                                                                            props