Cockpitbuilders.com
Main => General Discussion Board. => Topic started by: Mach7 on August 29, 2020, 02:24:23 AM
Hello Builders,
Hope everyone is making it through this pandemic.
Here is an update on my revised Hydraulic control panel, I was lucky enough to find some 146 specific gauges but I had to re-write the pressure programs to adjust for the variance in the (new) gauge voltage requirements.
I wanted to implement the same script for the quantity gauges, but these gauges require the full 5 volts just to drive the needles to the 'minimum' dispatch mark, so they were subsequently hard wired into the circuit to allow indication once the Batteries were selected online.
Jim.
https://www.youtube.com/watch?v=3tOwBt2L5S0
Beautiful and impressive. Nice work!