Will Depart in...
Started by jackpilot, June 10, 2022, 10:58:00 AM
0 Members and 1 Guest are viewing this topic.
Quote from: MistyBlue on June 01, 2022, 02:12:58 PMI also finally got my 737-700 CB panels in. They will definitely add to the immersion when complete. It's going to take a lot of tweaking to get them to fit properly as the rear flange of the FDS shell is interfering with the CB's, which are mounted externally on my roll away rear bulkhead. Turns out when you roll the bulkhead up to the back of the FDS shell the flange blocks some of the CBs at the top. As with most things in this hobby, you have to do a lot of custom work and tweaking to get what you really want.
Quote from: jackpilot on June 10, 2022, 10:58:00 AMHi Tony,Where did you get the breakers rings ?Jack
Quote from: jackpilot on June 10, 2022, 11:37:12 AMLucky B..... Any chance they could be 3D printed ?Any volunteer ?
Quote from: ame on June 10, 2022, 01:55:28 PMQuote from: jackpilot on June 10, 2022, 11:37:12 AMLucky B..... Any chance they could be 3D printed ?Any volunteer ? I did a design for 3D printed circuit breakers. They have a switch for state, and a solenoid to pop the button out.I'm pretty sure I wrote about it here, but I can't find the post.
Quote from: MistyBlue on June 11, 2022, 07:43:13 PMMaybe I misunderstood, but I thought Jack was only looking for the breaker ring locks, not the entire breakers.
Quote from: MistyBlue on June 11, 2022, 08:08:41 PMShould be able to make a 3D model of these. I had to really pry it open to pop it off. Not sure the PLA would hold up without splitting. Might have to use ABS or something....And great work on those breakers!
Page created in 0.096 seconds with 33 queries.