Cockpitbuilders.com
Main => General Discussion Board. => Topic started by: Reco on June 09, 2020, 06:42:43 PM
Hi all
Wanting some advice on what axis should be used on the BU0836X board for helicopter control
i have the X and Y axis hooked up for the cyclic ( ailerons and Elevator)
but would like to find out if I should set the pedals collective and throttle to any particular axis on the board
Cheers
Rhys
Not sure it matters which one ?
:(
X & Y in windows show up in the BOX makes it easier for calibration if that's your main control. Makes it easier to see the center position.
All others are individuals.
As far as the sim is concerned if calibrating through FSUIPC, makes no difference, an input is an input is an input.
Trev
Thanks for that
Cheers
Rhys