Cockpitbuilders.com
Prepar3d => Prepar3d - General Discussion => Topic started by: Bob Reed on February 01, 2017, 12:13:28 PM
So is there a way to tune the nav2 radio without actual hardware? My Nav 2 radio is stuck on 108.00. Anyway around this? Any idea why it may be stuck there? I can not find where it is accessing this information.
In Prosim,
All frequencies can be tuned from the CDU
In PM too.
Go to the nav/rad page
Jack
That's his problem. In Pm it doesn't matter what he tries to type in for nav 2 it just resets to that number. I wondered if maybe he had to tell prepared the aircraft has a nav2 lol
Quote from: jackpilot on February 01, 2017, 12:56:18 PM
In PM too.
Go to the nav/rad page
Jack
As Trevor has stated, if I change it in the CDU in PM, it just switches back to 108.00. Very strange indeed. I have to take a look at what Trevor is saying. I am using the PM 737 800.
I suppose you have unchecked Auto-tune?
I found the issue. In the radio software (hardware I am using) Nav 2 was set even though there is no hardware. Eliminated that entry and now I can tune Nav2 in the PM CDU. Now if I can just find why my landing gear just drops from time to time. Always when I am on decent.... Will do more looking.
QuoteNow if I can just find why my landing gear just drops from time to time
I think that's an automatic feature on the Airbus 737.
Quote from: RayS on February 07, 2017, 10:02:08 AM
QuoteNow if I can just find why my landing gear just drops from time to time
I think that's an automatic feature on the Airbus 737.
Um...... NO....... ;D