Print Page - Control axis setup for helicopter on Loe Bodnar board

Title: Control axis setup for helicopter on Loe Bodnar board
Post by: Reco on June 09, 2020, 06:42:43 PM

Hi all

Wanting some advice on what axis should be used on the BU0836X board for helicopter control

i have the X and Y axis hooked up for the cyclic ( ailerons and Elevator)
but would like to find out if I should set the pedals collective and throttle to any particular axis on the board

Cheers

Rhys

Title: Re: Control axis setup for helicopter on Loe Bodnar board
Post by: jackpilot on June 10, 2020, 03:57:13 AM

Not sure it matters which one ?
:(

Title: Re: Control axis setup for helicopter on Loe Bodnar board
Post by: Trevor Hale on June 10, 2020, 09:25:00 AM

X & Y in windows show up in the BOX makes it easier for calibration if that's your main control. Makes it easier to see the center position.

All others are individuals.

As far as the sim is concerned if calibrating through FSUIPC, makes no difference, an input is an input is an input.

Trev

Title: Re: Control axis setup for helicopter on Loe Bodnar board
Post by: Reco on June 11, 2020, 08:21:24 PM

Thanks for that

Cheers

Rhys

Cockpitbuilders.com

Main => General Discussion Board. => Topic started by: Reco on June 09, 2020, 06:42:43 PM