Print Page - Rotary Switches with long shaft

Title: Rotary Switches with long shaft
Post by: kozak737 on September 03, 2010, 11:24:04 AM

Hi,

I try to put the rotary switches with long shaft and i don't understand how it is possible to put on the top the knobs, since it is too long. Should I cut the shaft?

Regards
Constantinos

Title: Re: Rotary Switches with long shaft
Post by: matta757 on September 03, 2010, 11:35:35 AM

That's what I did...

Title: Re: Rotary Switches with long shaft
Post by: jackpilot on September 04, 2010, 03:59:12 AM

Install the rotary tight and then spend a little time measuring carefully because if shaft is cut too short you loose the rotary!! Allow 3 to 4 mm between the panel surface and the bottom of the knob.

Cockpitbuilders.com

Main => Help and Support => Topic started by: kozak737 on September 03, 2010, 11:24:04 AM