Text only | Text with Images

Cockpitbuilders.com

Main => General Discussion Board. => Topic started by: XOrionFE on October 14, 2011, 08:01:36 AM

Title: Missing terminals at ORBX Airports?
Post by: XOrionFE on October 14, 2011, 08:01:36 AM
Hello all,

I doubt anyone has run into this but posting as a longshot.    I have a lot of the ORBX scenery including recently purchased Brisbane (YBBN) and Melborne Intl (YMML) airports along with FTX Australia SP4 (all of Australia).   I have also installed all patches from ORBX.    For whatever reason these two airports work fine with the exception that I am missing the terminals completely.    Cargo areas, peopleflow, runways taxiways, aprons, vehicles, and jetways, even signs, are all fine.   It is just the terminals that are missing from view.   Their shadows are there even!    I have not been able to figure out what is wrong.    I loaded on my desktop computer same way to check it out and they are fine but not working on my Cockpit setup.   I have played with all the display sliders and reinstalled, etc.    The only thing I can think of at this point is that somehow it is not compatible with a TripleHead2Go 3 screen setup.   I even tried with 2 different warping softwares. 

Anyone else using these in their pit right now?  Seen this issue?

Thanks,
Scott
Title: Re: Missing terminals at ORBX Airports?
Post by: jetpilot on October 14, 2011, 08:10:58 AM
Hi Scott,
Do you already tried loading the scenery with both DX10 selected and non selected. Usually that correct this issue.
Roberto
Title: Re: Missing terminals at ORBX Airports?
Post by: XOrionFE on October 14, 2011, 08:24:43 AM
Not with DX10 yet.   I will try that now though.
Title: Re: Missing terminals at ORBX Airports?
Post by: XOrionFE on October 14, 2011, 08:40:49 AM
You da man Roberto!!!   That fixed it!  Turned on DX10 and the terminal showed up.   Didnt realize I need that on.  Thanks so much.....

Scott

PS - can wait unit November 5th weekend....should be a lot of fun

Text only | Text with Images