Print Page - How do I Illuminate a panel switch title.

Title: How do I Illuminate a panel switch title.
Post by: chelseaboy on April 24, 2014, 02:10:10 AM

Does anyone know of a tutorial on how to illuminate a switch panel title.
I.E. when I throw the switch, the ON title would light up.

Title: Re: Illuminated a panel switch title.
Post by: Jetcos on April 24, 2014, 04:25:39 AM

Can you show us the switch? Light specs are important

Are you using any type of Interface card?

Title: Re: Illuminated a panel switch title.
Post by: chelseaboy on April 24, 2014, 05:13:55 AM

I have a leo bodnar BU0836X card and plan to use a basic on-off toggle switch.
Not sure on the light specs. I tend to review a number of different ways of making a panel then teach myself how to do it.
Might go down the led route, having just purchased an electronic breadboard.
Ps thanks for the fast response.

Title: Re: How do I Illuminate a panel switch title.
Post by: LORENZO on August 14, 2015, 01:05:47 PM

Hi Daren
i would look at going down the double pole road with the toggle switch,
one side to switch the card for emulated input to the pc
and the other set of contacts to switch a separate circuit for a basic led with resistor circuit powerd seperatley

can do you a wiring diagram if required

have fun

lorenzo

Title: Re: How do I Illuminate a panel switch title.
Post by: chelseaboy on October 10, 2016, 04:42:08 AM

Lorenzo
Just read you reply
Any chance you could draw me the wiring diagram?

Title: Re: How do I Illuminate a panel switch title.
Post by: iwik on October 10, 2016, 08:49:38 AM

Hi,
If all you want to do is light a Led when switch is closed just wire according to attached
file.
Regards
les

Cockpitbuilders.com

Main => Builders Discussions => Topic started by: chelseaboy on April 24, 2014, 02:10:10 AM