Print Page - FDS OVHD Help

Title: FDS OVHD Help
Post by: 737man on May 24, 2015, 08:51:11 PM

Hello,
I am connecting my fds Overhead to Prosim. The usb cable reads and I can see the board on the Prosim Comfig screen. The 12v power is connected. I am getting nothing when I do a test. The dc amps screen and flt alt & land alt work fine. Any thoughts? The board was working before it was connected. How can I find out if the board is bad?

Help,
Lance

Title: Re: FDS OVHD Help
Post by: Bob Reed on May 25, 2015, 05:32:10 AM

Is this a new purchase? If so I would contact FDS. If not, still might not hurt to contact them.

Title: Re: FDS OVHD Help
Post by: FredK on May 25, 2015, 10:17:05 AM

Lance -

Is this a complete new OH from FDS? Then best to direct the question there as Bob has suggested.

If not, is the interface a FDS SYS board or something else?

If the interface is a FDS SYS board you can use FDS InterfaceIT to check the function of all switches and leds etc. independent of ProSim.

Fred

Title: Re: FDS OVHD Help
Post by: 737man on May 25, 2015, 10:44:52 AM

Cheers...

Cockpitbuilders.com

Main => General Discussion Board. => Topic started by: 737man on May 24, 2015, 08:51:11 PM