Print Page - CNC made flapgauge

Title: CNC made flapgauge
Post by: Wendy on January 21, 2010, 11:50:34 AM

Just wanted to show you the flapgauge I'm building. I have made a picture without the transparent cover because the light reflected to much.

Comments are greatly appreciated, negative or positive.

(https://www.cockpitbuilders.com/proxy.php?request=http%3A%2F%2Fwww.querit.eu%2FFS%2FFlapGauge_Wijzerplaat.jpg&hash=9abb5ea99d546ddfd95b386aa1417c3822670d6a)

Regards, Wendy

Title: Re: CNC made flapgauge
Post by: Bob Reed on January 21, 2010, 11:58:07 AM

That is awesome looking. Going to drive it with a servo?

Title: Re: CNC made flapgauge
Post by: ivar hestnes on January 21, 2010, 11:59:33 AM

This looks very good. Thumbs up :)

Title: Re: CNC made flapgauge
Post by: when acting as a wave on January 21, 2010, 12:00:31 PM

Very nice! Beautiful text.

Title: Re: CNC made flapgauge
Post by: Wendy on January 21, 2010, 12:09:16 PM

Yes, I'm going to use servo's with Phidgets to drive the needles.

Regards, Wendy

Title: Re: CNC made flapgauge
Post by: Boeing Skunk Works on January 21, 2010, 02:06:50 PM

Looks really nice. Wish I had the room.

Title: Re: CNC made flapgauge
Post by: XOrionFE on January 21, 2010, 02:22:17 PM

WOW. Absolutely fantastic looking Wendy!

Two Thumbs up!

Scott

Title: Re: CNC made flapgauge
Post by: Wendy on January 21, 2010, 09:52:36 PM

Thank you all for the nice comments.

Regards, Wendy

Cockpitbuilders.com

Main => Builders Discussions => Topic started by: Wendy on January 21, 2010, 11:50:34 AM