Print Page - FSC TQ Flaps

Title: FSC TQ Flaps
Post by: Chantry23 on September 21, 2017, 05:03:32 AM

Hi

I have a problem with the flaps on my TQ. Every position is recognised except 0 (flaps up)

I can get flaps up by using the keyboard but that's not the point! I am using Project Magenta software. Is this a question of calibration? I have tried to calibrate but have not found the answer.

Martin

Title: Re: FSC TQ Flaps
Post by: jackpilot on September 21, 2017, 05:15:24 AM

There is a section on flaps in the PM manual.
Are you using a pot for flaps?

Check
http://www.cockpitbuilders.com/community/index.php?topic=686.msg5238#msg5238 (http://www.cockpitbuilders.com/community/index.php?topic=686.msg5238#msg5238)

Title: Re: FSC TQ Flaps
Post by: Bob Reed on September 21, 2017, 05:51:21 AM

Are you using FSUIPC to calibrate?

Cockpitbuilders.com

Main => General Discussion Board. => Topic started by: Chantry23 on September 21, 2017, 05:03:32 AM