Well I have not streamed since Rays and I built the shell. As of today , in the 20 minutes or so , will be streaming live once again. This will be me working on the sim, flying the sim and chatting live with the likes of Trevor on Skype. Hop over and take a look...
http://twitch.tv/breed445 (http://twitch.tv/breed445)
:D
Dang, I missed your show Bob. I was on my way from EGLL/EIDW this afternoon in the 738 with PRO-ATX. Needless to say I need to get a lot better at RNAV approaches.
Great Bob,
I didnt see it live but saw a couple of the recordings. Great idea to record the build!
Looking good!
Scott
Ya I ran into a couple more tech issues that I hope I have cleared up once and for all. I will try to be a little more accurate with stream times in the future. And yes the videos will always be there. Tonights went pretty well.....
I am live! sort of...lol
Great idea - i'm tuned in!
Going live now. Going to setup a print on the 3D printer. Hopefully that will go well. Going to see if I can mount all the panels for one last test fit before all the wiring and interfacing starts...
Bob
FYI - I see no live feed here.
Fred K
Quote from: FredK on January 22, 2018, 03:31:25 PM
Bob
FYI - No live feed here.
Fred K
No, I just went off line a few minutes ago. I streamed for over 3 hours today and I have the MIP mounted.... I will post a pic shortly.
I am live!
All done. Short stream. Just moved the yoke back about 3"...
We are live. Testing the interface and Korrys.
Stream is over and what a stream it was. All the korrys are tested and working with the
64 out Ruscool interface. Will be back at it tomorrow...
Hey Bob,
When you go live, is it possible to post the link to your channel as well? (Or maybe even put it in your signature?) When you say you're live, some folks have no idea what you're talking about. (Or can't find the link!) ;)
Quote from: RayS on January 26, 2018, 09:22:00 PM
Hey Bob,
When you go live, is it possible to post the link to your channel as well? (Or maybe even put it in your signature?) When you say you're live, some folks have no idea what you're talking about. (Or can't find the link!) ;)
LOL!!! That is a really good point! Will do!
We are live now! Link is in my signature!
Offline now.. Be back later....
Going live at 12:30pm eastern time. We will be programming the Ruscool 64 output card and doing a little flying to test. http://twitch.tv/breed445 (http://twitch.tv/breed445)
Going live at 1:00pm Eastern. Flying from KPDX to KSLC...
http://twitch.tv/breed445 (http://twitch.tv/breed445)
Streaming live flight at 12:00pm Eastern. AAL1219 KSLC to KDFW
Http://twitch.tv/breed445 (Http://twitch.tv/breed445)