Cockpitbuilders.com

CockpitBuilders.com - Main => Builders Discussions => Topic started by: kattz on September 29, 2019, 02:29:15 pm

Title: Calling all B737NG/B757 mechs and crew...
Post by: kattz on September 29, 2019, 02:29:15 pm
I was looking at adding a mechanism to the crossover tube to simulate the 5 lb breakout from centered for the elevators.  (Yes, Jenny, there is an actual center...)

Please see attached. 

You cannot see attachments on this board.

Is this breakout mechanism in the schematic to allow one end of the torque tube to disengage from the other end in case of a jam?

Otherwise, what's the purpose?

Thanks.

Kevin