PFD Bezel measurements needed

[ifeliciano]

I have the documents from MARKUUPILOT with the overall size of the PFD, ND, bezel, but i'm not finding the specific width of the bezel. I have marked the inserted image with two locations, A & B. Can someone with a OEM 738 MIP assist with measurements?

[jeffreyk]

Hi there!

Actually it's not an OEM MIP you're after but an OEM DU.

I doubt simmers have those but if one does, I would like to know too for my own future build

Perhaps someone from maintenance or a helpful pilot can give some guidance on your question.

Cheers,
Jeffrey

[Karl737]

Hi guys,

A= 11/32"
B= 3/4"

Cheers,
Karl

[Joe Lavery]

Or if you work in mm,

A = 8.7mm
B = 19mm

These are almost exact conversions but many third party MIP frames will be 9 and 19mm
In fact my Engravity MIP is 11mm and 20mm

Joe.

[Bob Reed]

Actually the bezels and glass on my MIP are real. If you need any other measurements let me know.

[ifeliciano]

Thank you all!!

[ifeliciano]

Forgot to ask, but what does the top of the bezel and the gaps between the bezels measure ?

[Bob Reed]

D=5mm As for the gap, remember that these are slide out units so that is going to be a little different on every set. Mine are right together so I can not help much.

[ifeliciano]

D=5mm As for the gap, remember that these are slide out units so that is going to be a little different on every set. Mine are right together so I can not help much.

Thanks Bob.  I just literally became aware the DU's slide out with the bezel attached (reading Flaps 2 Approach site). I'll probably set the gap somewhere between 2mm and 4mm. 

[jackpilot]

Basically no gap, one or two mm max

[ifeliciano]

Basically no gap, one or two mm max

Ok. Thanks Jack!

[Karl737]

If you are OCD like me, gap is 1/16th (Boeing use imperial measurements) or 1.6mm.

Cheers,
Karl