FSC TQ Flaps

[Chantry23]

Hi

I have a problem with the flaps on my TQ.  Every position is recognised except 0 (flaps up)

I can get flaps up by using the keyboard but that's not the point!  I am using Project Magenta software.  Is this a question of calibration?  I have tried to calibrate but have not found the answer.

Martin

[jackpilot]

There is a section on flaps in the PM manual.
Are you using a pot for flaps?

Check
http://www.cockpitbuilders.com/community/index.php?topic=686.msg5238#msg5238

[Bob Reed]

Are you using FSUIPC to calibrate?