Skip to content

Rotary Switches with long shaft

Started by kozak737, September 03, 2010, 11:24:04 AM

Previous topic - Next topic

0 Members and 0 Guests are viewing this topic.

kozak737

Hi,

I try to put the rotary switches with long shaft and i don't understand how it is possible to put on the top the knobs, since it is too long. Should I cut the shaft?

Regards
Constantinos

matta757


jackpilot

Install the rotary tight and then spend a little time measuring carefully because if shaft is cut too short you loose the rotary!! Allow 3 to 4 mm between the panel surface and the bottom of the knob.


Jack