Cockpitbuilders.com
Main => General Discussion Board. => Topic started by: Bob Reed on February 16, 2018, 11:44:06 AM
Printer is working great. So much so I decided to try my hand at a panel. Found one online but I may end up designing my own. Just need to get rid of the travel lines.
Looks good Bob! Bit of sanding and you are sorted!
Ya that is just how it came off the printer. I may re design it but we will see..
Hi Bob,
Are you using Cura, Simply3d or something else? Also, is that an In-fill hatch pattern that's causing the irregular lines and thereby, not making it smoother (or similar looking). And, what size nozzle are you using?
I am just curious, because I'm learning from watching others...
John
Quote from: blueskydriver on February 16, 2018, 05:36:31 PM
Hi Bob,
Are you using Cura, Simply3d or something else? Also, is that an In-fill hatch pattern that's causing the irregular lines and thereby, not making it smoother (or similar looking). And, what size nozzle are you using?
I am just curious, because I'm learning from watching others...
John
I am using Cura 3.2 and for the cross hatch.. I have no idea. It is just how it was sliced. I have a .4 nozzel.
going to a 100% infil may eliminate most of the lines, but hard to say, and would totally triple print time..