Smallest width of a MIP base

[kurt-olsson]

Hi

My build have minimalistic target and a challenge of being in a small room.
Therefore i want my front window post to be as close to the wall as possible. Kind of like the jetmax.

Right now i have descided for a 40cm width MIP sidewall.

What do you think of this? What does your measure from the panel to windowpost? Do you think i will get into problems with only 40cm?

Thanks.

[Bob Reed]

So are you saying you will chop the FO's side down a little? Not sure I understand what measurement you are looking for. My cockpit I played with the width but not in the front or MIP area. I made it  a little narrower by making my back wall not as wide as it is supposed to be. Cut about a foot to a foot and a half from the overall width.

[kurt-olsson]

Sorry, should have made it more clesr that it is the sidewalls for the MIP structure and not the main panel itself. If i understand you have done that by cutting a foot from yours.

[Bob Reed]

Sorry, should have made it more clesr that it is the sidewalls for the MIP structure and not the main panel itself. If i understand you have done that by cutting a foot from yours.

A foot to a foot and a half in the back. I forget I can run down and measure it..

[Bob Reed]

The very back of the cabin is 95" wide.

[kurt-olsson]

Thanks a million, will do thesame here!

[Bob Reed]

Thanks a million, will do thesame here!

Check the width of the seats you want to use. It does make the cabin a little narrower....

[Joe Lavery]

Good choice Bob that's pretty much the size of a sheet of MDF or plywood... 

[Bob Reed]

Good choice Bob that's pretty much the size of a sheet of MDF or plywood... 

My  floor section is actually a little bigger then that. But hey it works well! I had a TON of help with it. Could not have don it without Rays and Don....