CANbus plug and play ready buildt

[Joerg Weinmann]

Dear all,

we are very proud to invent a total new system to the flight sim community. Attached a link to can driven instruments and panels. System will be open for any user to program I/O by theirself.
for more information feel free to contact us.

http://youtu.be/j6etc9j91ys

regards

[archen]

Looks great! Where can I find more information about the product?

Anders

[fsaviator]

Anders,
Joerg is with Simparts.de

http://www.simparts.de/epages/15465782.sf/en_US/?ObjectPath=/Shops/15465782/Products/SYS-MCO

This is a very nice system...  one controller, and a single cable that daisy chains instruments, if I remember right.  I need to get over to his shop and take a look at the final version in person.

[ivar hestnes]

That looks very interesting 

[Joerg Weinmann]

Thanks for your comments. In the new Inerthya CAN system you will only need one master controller and a little piece of software called workspace. No calibration. All Panels available in the future as well in CAN have own firmware, no USB and no driver problems. Absolute new system. And you can use different simulation software with same hardware without different drivers. Implementation of real panels and instruments possible as well.
We will keep you informed. More information from
www.simmeters.com or i-jetpilot.com

greetings

Jörg

[hexpope]

About time the "CANbus" is starting to be used. It is the way forward along with Ethernet, but I fear it will take a few more years for builders to migrate onto this platform. I will keep an eye on your progress with this feature or protocol.

Best of luck